Instructions

• Use safety glasses. Protect hands and skin from exposure using gloves and appropriate clothing.
• Ensure adequate ventilation.
• Substrate must be free from grease, dirt or dust.
• Ambient temperature must be between 4° C and 35° C.
• Do not apply when ambient humidity exceeds 90%.
• Mix dry component A 12% weight to resin component B 88% weight. Use (industrial) mixer.
• Mix for at least 3 minutes.
• Do NOT use any thinner.
• Use knife or airgun/spraygun for application.
• Film thicknesses can be varied from between 3mm to 8mm WFT.
• DFT >3mm, <6mm for Safe Touch purposes.
• DFT >5mm, < 19mm for thermal insulation purposes.
• Cross layer-application is recommended, wet-in-wet.
• Measure WFT during application. Product expands up from between 5% to 15% during application.
• nC® ProTherm Safe Touch will decrease 10% in thickness during curing time.
• Table for curing times, at ambient temperature of 20° C and 60% humidity:
  

  Surface	Curing time
  All metals, indoor	12 hrs
  All metals, outdoor	24 hrs / 48 hrs, depending on temperature and humidity
  Product can be exposed to full rain after 12 hours. Full cure after 7 days

   

• Let surface dry in for at least 6 hours before forced drying by means of blower or heater at 55° C max.
• Surface can be painted over.
• Clean knifes, nozzles with water immediately after any stop.
• Wash hands and face after every stop.

LIMITATIONS

• Do not use as a final floor covering.
• Do not use under water.
• Do not allow application during freezing temperatures.
• Do not rely on visual measurement for coating thickness. Always use a wet film thickness (WFT) and/or dry film thickness (DFT) gauge in several areas to ensure proper application thickness.